No leaks? Great, turn on the water again and let the tank fill up. If you do have a leak, they can usually be fixed by tightening the area that is leaking. Look and feel around the tank to see if there are any leaks. Let it run so you just have about an inch in the tank and shut it off. Broken porcelain and stripped threads will be more of a headache than a slight leak that can be easily stopped.
It is not always a good thing to over tighten.
How to install toilet bolts to right height how to#
When people are learning how to install a toilet, they like to tighten the daylights out of everything. Just hand tight at the toilet is sufficient. Some toilets even come with the hose.Īttach the small end to the toilet shut off valve and the large plastic end to the toilet. You can pick these up at any hardware store for a minimal cost. The easiest way to get water to you toilet is with a braided hose. Tighten the bolts in the same fashion as the bowl and make sure you don't over tighten! There will be a rubber washer for inside the tank a steel washer and nut for outside. Place the tank on the bowl and insert the bolts through the holes. Be sure the taper is facing the correct way. Slip this rubber gasket on around the pipe that is on the bottom of the tank. Generally the toilet tank parts are two bolts that hold the tank on and a large rubber gasket that goes between the tank and bowl. Step 3 - Toilet tank partsĭepending on the type of toilet you are installing, this step can vary a little bit. This is the next step in how to install a toilet. Tighten them both at the same time (jump back and forth) to be sure that the bowl is level and doesn't crack. Do not tighten on bolt fully before the other bolt. Be sure to put the plastic bolt cover plate on first, then the washer and then the nut.
:no_upscale()/cdn.vox-cdn.com/uploads/chorus_asset/file/19497050/installing_toilet_8.jpg "how to install toilet bolts to right height")
Push down on the bowl so the wax ring is smooshed (yes, I said smooshed) and seals the bowl to the flange. Place the bowl on the flange ensuring that the bolts go through the holes and are sticking straight up. Put the toilet bolts in the slots in the flange.
0 kommentar(er)
